bike work table

[zed]

Originally Posted by CasterTroy

My setup works great. I can lift the bike 40" in the air and work on the bottom of the bike and not have to crouch over. The front chock works OK but I always have my straps on the canyon dancer tied down like you see in the pics "just in case" because you CAN tug on the bike in that chock and get it to lean. But as far as the LIFT itself....it's very stable at full height.


My buddy Brian has the $700 with the freakin cast iron VICE on the front wheel.....it weighs about 500 pounds and you can lift the bike 4ft in the air, sit on it and lean all the way off the bike shaking and rocking the bike and it nor the stand will budge.

But try moving it around in the shop.

Mine will roll anywhere in the garage I need it too even fully extended

I'm used to working on one like the first one I posted that I want to get. I did think about one like you have but wasn't sure about the stability of it with a bike on it and moving/jerking around on it like you sometimes have to do.

thanks for letting me know about it. that one is closer to me being able to afford and better than the table I made.

[zed]

it's in there, will be plenty of room after I get the motor in the 11.