Go Back   Two Wheel Fix > In the Garage or Shop > Aftermarket Modding

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-15-2011, 09:20 PM   #1
derf
token jewboy
 
derf's Avatar
 
Join Date: Nov 2008
Moto: CBR 900, KLR ugly ass duckling, Gas Man
Posts: 10,799
Default Garmin users: How did you wire yours up? Here is how I did mine

Just wondering how everyone else wired theirs up? I added the hard wires to my pre-existing fused and relayed accessory system on both bikes. I realized now that I could have easily saved myself a ton of trouble if I would have just looked up how others had done it first.

The following applies to both the CBR and the KLR

I still have not cut into either bikes stock electrical system, except for the horn to provide a power signal for the relay. I wound up just going off the existing set of wires I had installed already, ran a new positive from the fuse box, and jacked into the ground wires I had already added behind the dash. Since the Garmin only uses a power and ground to supply the bike harness thats all I needed. I used a universal two prong plug so I can switch the GPS between bikes.



http://www.twowheelfix.com/showthrea...highlight=plug
__________________
derf is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 12:33 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.