Machinist/Fabricators in the house?

G-Rex · 01-03-2011, 01:51 PM

Thanks for the link!

I'll powdercoat it black, so the regular sheet stainless would be sufficient.

I'm in Oklahoma City. It looks like the closest place to me is 90 miles away in Tulsa.

I doubt I have a steady enough hand to cut the metal cleanly with a jigsaw, and I'm a bit OCD about the quality of things I buy/put on my motorcycles.

I think my first order of business is to draw up a couple of templates so I can start getting some quotes. I'm sure with me only wanting a couple, the cost will be up there. I know there are some people on the BMW boards wanting similar, so maybe I can make a few sets to sell and defray the cost.

01-03-2011, 01:51 PM	#11
G-Rex Where to next? Join Date: Nov 2008 Location: OK to the C Moto: TL1000R, Hayabusa, R1150RT Posts: 1,333	Thanks for the link! I'll powdercoat it black, so the regular sheet stainless would be sufficient. I'm in Oklahoma City. It looks like the closest place to me is 90 miles away in Tulsa. I doubt I have a steady enough hand to cut the metal cleanly with a jigsaw, and I'm a bit OCD about the quality of things I buy/put on my motorcycles. I think my first order of business is to draw up a couple of templates so I can start getting some quotes. I'm sure with me only wanting a couple, the cost will be up there. I know there are some people on the BMW boards wanting similar, so maybe I can make a few sets to sell and defray the cost. __________________