Handlebars

ZUKIMON · 03-23-2009, 03:48 PM

I noticed yesterday that my bars are not right for me. They need to be angled more forward and a little higher wouldn't hurt either. I was just out looking at them and there is only one bolt holding them clamped on each end. There is also a small tit that locates them for the angle. Would I be making a mistake if I ground that tit off so I could change the angle on them? I wouldn't ask but, these have only one clamp bolt per side whereas my old bikes have had two. The tit is so little that I hoestly can't see it doing much. ??? HELP!

03-23-2009, 03:48 PM	#1
ZUKIMON Is this thing on? Join Date: Feb 2009 Location: Ashe Co, NC (Near Boone) Moto: '01, 929RR Posts: 398	Handlebars I noticed yesterday that my bars are not right for me. They need to be angled more forward and a little higher wouldn't hurt either. I was just out looking at them and there is only one bolt holding them clamped on each end. There is also a small tit that locates them for the angle. Would I be making a mistake if I ground that tit off so I could change the angle on them? I wouldn't ask but, these have only one clamp bolt per side whereas my old bikes have had two. The tit is so little that I hoestly can't see it doing much. ??? HELP! __________________ Dirty Harry said there's nothing wrong with a little shooting, as long as the right people get shot.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode