2001 Suzuki TL1000R vs. 2002 Honda CBR 954RR... another biased comparison. - Page 6

Mr Lefty · 11-23-2008, 08:39 PM

damn those things are wheelie machines and your gonna GO DOWN?!

also remember for your road trips that's gonna murder your range and fuel economy

tlstreak · 11-23-2008, 08:43 PM

Up 2 in the rear is a great gearing for it.

I would recommending sticking with steel sprockets and the 530 for mileage.
Be very careful with the oil drain plug, they are very known to strip out.

Braided lines will make the brakes ok with a decent set of pads.

IIRC set the forks around 5mm showing above the top clamp once you get the suspension set. That was about the most common setting on the TL, I would start adjusting from there. After the weight is set. You will feel the shift instantly and figure out where you like the front end yourself.

Tlzone and Tlplanet are you 2 best sources of info.

OneSickPsycho · 11-23-2008, 08:43 PM

Quote:

Originally Posted by Ebbs15

damn those things are wheelie machines and your gonna GO DOWN?!

also remember for your road trips that's gonna murder your range and fuel economy

I am yet to wheelie this thing... Pretty good considering I wheelied the CBR all the fucking time... I'm sure it will happen one day...

Not worried about fuel economy... 3/4 of the time I ride mid way through the revs or higher anyway... Plus, it's a 996cc liquid cooled v-twin... Gas mileage was murdered long ago... Not to mention, stopping every 120 miles is not necessarily a bad thing...

FT BSTRD · 11-23-2008, 08:44 PM

Drewp ran our last group ride with all V-Twins (Buells, RC51, SV's).

He made the comment that it was different riding with I4 groups. Different sweet spots. All torque less top end.

I am biased toward v-twins as well. I think part of the draw is that they AREN'T I4's.

I4's are really refined and are fantastic machines. V-Twins are not as refined. They are rougher around the edges.

I want a bike that is hot, vibrates, smells like gas and burning souls, sounds like you are running a chainsaw through a snare drum, and scares the piss out of you at least once every time you take it out of the barn.

There are so many ways that I4's are superior to many V-Twins. There are so many ways that even with that superiority, I will pick a V-Twin over an I4 given the chance.

The TLR is on my short list of wanted bikes. Ducati, RC51, Moto Guzzi, Aprilia, are all on the list.

Mmmmmmm. Dead Sexy.

Dnyce · 11-23-2008, 08:45 PM

goin down 3t? think u mean goin up....

NONE_too_SOFT · 11-23-2008, 08:46 PM

Quote:

Originally Posted by OneSickPsycho

I am yet to wheelie this thing... Pretty good considering I wheelied the CBR all the fucking time... I'm sure it will happen one day...

Not worried about fuel economy... 3/4 of the time I ride mid way through the revs or higher anyway... Plus, it's a 996cc liquid cooled v-twin... Gas mileage was murdered long ago... Not to mention, stopping every 120 miles is not necessarily a bad thing...

it is when you're putting new rubber on it every 2 months. plus the wear on the engine will increase. and the chain. and the sprockets. but if it gets your rocks off who gives a flying fuck.

OneSickPsycho · 11-23-2008, 08:46 PM

Quote:

Originally Posted by tlstreak

Up 2 in the rear is a great gearing for it.

I would recommending sticking with steel sprockets and the 530 for mileage.
Be very careful with the oil drain plug, they are very known to strip out.

Braided lines will make the brakes ok with a decent set of pads.

IIRC set the forks around 5mm showing above the top clamp once you get the suspension set. That was about the most common setting on the TL, I would start adjusting from there. After the weight is set. You will feel the shift instantly and figure out where you like the front end yourself.

Tlzone and Tlplanet are you 2 best sources of info.

I'm already on TLzone... I just need some patience to start reading through all that stuff...

I will most certainly stick with steel sprockets for mileage... good idea staying with 530... or maybe go with some of those uber-cool long mileage ones and do the 520... gotta do more research...

I've seen lotsa guys, mostly TLS guys, going with Busa calipers... Not sure if that'd be worth it as the TLR already has 6-pots... Again, gotta read more...

Mr Lefty · 11-23-2008, 08:47 PM

Quote:

Originally Posted by OneSickPsycho

I am yet to wheelie this thing... Pretty good considering I wheelied the CBR all the fucking time... I'm sure it will happen one day...

Not worried about fuel economy... 3/4 of the time I ride mid way through the revs or higher anyway... Plus, it's a 996cc liquid cooled v-twin... Gas mileage was murdered long ago... Not to mention, stopping every 120 miles is not necessarily a bad thing...

true...

tlstreak · 11-23-2008, 08:50 PM

Busa are more for appearence. Your choice is 6 pot or 4 pot. The 4 pot are the better for overall feel and the 6 pot are for stopping. You have 6 pot already. Put a good set of lines and your set unless you want to mod cosmetic.

OneSickPsycho · 11-23-2008, 08:51 PM

Quote:

Originally Posted by FT BSTRD

Drewp ran our last group ride with all V-Twins (Buells, RC51, SV's).

He made the comment that it was different riding with I4 groups. Different sweet spots. All torque less top end.

I am biased toward v-twins as well. I think part of the draw is that they AREN'T I4's.

I4's are really refined and are fantastic machines. V-Twins are not as refined. They are rougher around the edges.

I want a bike that is hot, vibrates, smells like gas and burning souls, sounds like you are running a chainsaw through a snare drum, and scares the piss out of you at least once every time you take it out of the barn.

There are so many ways that I4's are superior to many V-Twins. There are so many ways that even with that superiority, I will pick a V-Twin over an I4 given the chance.

The TLR is on my short list of wanted bikes. Ducati, RC51, Moto Guzzi, Aprilia, are all on the list.

Mmmmmmm. Dead Sexy.

Good call. I was thinking as I was riding today... "I4's are sooooo smooth, refined, and boring... the v-twin has a SOUL..."

Quote:

Originally Posted by Dnyce

goin down 3t? think u mean goin up....

Fuck me, I'm retarded... yes, up...

Quote:

Originally Posted by NONE_too_SOFT

it is when you're putting new rubber on it every 2 months. plus the wear on the engine will increase. and the chain. and the sprockets. but if it gets your rocks off who gives a flying fuck.

Nah, I doubt it will have that big of an impact... I go through tires quickly anyway... and the wear on the engine... yeah, but I didn't buy the damn thing to putt around to bike nights... chain and sprockets... not worried about those either...

Quote:

Originally Posted by tlstreak

Busa are more for appearence. Your choice is 6 pot or 4 pot. The 4 pot are the better for overall feel and the 6 pot are for stopping. You have 6 pot already. Put a good set of lines and your set unless you want to mod cosmetic.

I sorta figured it was something goofy like that... Cosmetics aren't necessarily my thing either... In fact, I want it to look as ugly as possible.

11-23-2008, 08:44 PM	#54
FT BSTRD Tractor Driver Join Date: Jun 2008 Location: Franklin, TN Moto: Buell XB12X Ulysses Posts: 1,007	Drewp ran our last group ride with all V-Twins (Buells, RC51, SV's). He made the comment that it was different riding with I4 groups. Different sweet spots. All torque less top end. I am biased toward v-twins as well. I think part of the draw is that they AREN'T I4's. I4's are really refined and are fantastic machines. V-Twins are not as refined. They are rougher around the edges. I want a bike that is hot, vibrates, smells like gas and burning souls, sounds like you are running a chainsaw through a snare drum, and scares the piss out of you at least once every time you take it out of the barn. There are so many ways that I4's are superior to many V-Twins. There are so many ways that even with that superiority, I will pick a V-Twin over an I4 given the chance. The TLR is on my short list of wanted bikes. Ducati, RC51, Moto Guzzi, Aprilia, are all on the list. Mmmmmmm. Dead Sexy. __________________ "I do get tired of reading,'my buddy is a racer and says the Buell will never work' I always want to say 'Who the FCK is your buddy and is he faster than Shawn Higbee?" --Erik Buell*

11-23-2008, 08:45 PM	#55
Dnyce flyin high Join Date: Mar 2008 Location: cali Moto: 10speed huffy w/cards in the spokes Posts: 2,318	goin down 3t? think u mean goin up.... __________________ "Racing Is Life, Everything Before and After is Just Waiting" Steve McQueen

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

11-23-2008, 08:39 PM	#51
Mr Lefty TWFix Legend Join Date: Feb 2008 Location: Denver CO Moto: 01 BMW F650GS Dakar Posts: 15,677	damn those things are wheelie machines and your gonna GO DOWN?! also remember for your road trips that's gonna murder your range and fuel economy

11-23-2008, 08:43 PM	#52
tlstreak As Seen On TV Join Date: Nov 2008 Location: NE TN Moto: 01 929 Posts: 54	Up 2 in the rear is a great gearing for it. I would recommending sticking with steel sprockets and the 530 for mileage. Be very careful with the oil drain plug, they are very known to strip out. Braided lines will make the brakes ok with a decent set of pads. IIRC set the forks around 5mm showing above the top clamp once you get the suspension set. That was about the most common setting on the TL, I would start adjusting from there. After the weight is set. You will feel the shift instantly and figure out where you like the front end yourself. Tlzone and Tlplanet are you 2 best sources of info.

11-23-2008, 08:50 PM	#59
tlstreak As Seen On TV Join Date: Nov 2008 Location: NE TN Moto: 01 929 Posts: 54	Busa are more for appearence. Your choice is 6 pot or 4 pot. The 4 pot are the better for overall feel and the 6 pot are for stopping. You have 6 pot already. Put a good set of lines and your set unless you want to mod cosmetic.