Bar ends?

NONE_too_SOFT · 03-29-2009, 02:27 AM

I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all.

so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back.

Any ideas?

Amber Lamps · 03-29-2009, 07:17 AM

Quote:

Originally Posted by NONE_too_SOFT

I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all.

so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back.

Any ideas?

Swap them left to right?

Use some stainless washers to shim out the recessed side to match?

Trip · 03-29-2009, 10:54 AM

on the short one, you are going to have to attach the bolt not very far in at all and try to pull that one out some. It's a pain in the ass. If you put the bolt too far in it will expand and it won't budge.

on the long one, do the same with the bolt and beat it in with a rubber mallet to desired distance.

Amber Lamps · 03-29-2009, 12:33 PM

Quote:

Originally Posted by Trip

on the short one, you are going to have to attach the bolt not very far in at all and try to pull that one out some. It's a pain in the ass. If you put the bolt too far in it will expand and it won't budge.

on the long one, do the same with the bolt and beat it in with a rubber mallet to desired distance.

Well,there ya go!

Dave · 03-29-2009, 01:12 PM

yer kidding right?

HRCNICK11 · 03-29-2009, 01:18 PM

If its the stock ones the insert moves. There is a clip on it that digs into the inside of the bar itself.

03-29-2009, 02:27 AM	#1
NONE_too_SOFT Chopstix / \ Join Date: Feb 2008 Location: Akron OH Moto: 03 CBR RR Posts: 5,350	Bar ends? I've never had to deal with this before, but i cant figure out for the life of me how to install my bar ends. I took the one i did have off, and just tried putting the new one on in place. worked fine, but stuck out way too far. i thought i understood the mechanics to it (the mount you screw the actual bar end into screws into the clipon, if im not mistaken) but couldnt adjust that mount at all. so i go to the otherside, and have the exact opposite problem. the mount was recessed too far back. Any ideas?

03-29-2009, 01:12 PM	#5
Dave Chaotic Neutral Join Date: Feb 2008 Location: Cherry Hill NJ Moto: GV1200 Madura, Hawk gt Posts: 13,992	yer kidding right?

03-29-2009, 01:18 PM	#6
HRCNICK11 Canyon Carver Join Date: Nov 2008 Posts: 429	If its the stock ones the insert moves. There is a clip on it that digs into the inside of the bar itself.